Conrad CCW — home
Conrad crew removing sawn road panels on a downtown Denver street during a sewer line replacement

Job records

The work

No stock photos. Every frame below is a Conrad crew on a Denver-area job.

Request a quote

Photo log

Fourteen scopes, start to finish

Slab saws, core rigs, torches, and cranes. Some of these jobs ran on normal hours; a few ran late because the schedule said so. Full capabilities are on the service pages: concrete cutting, core drilling, selective demolition, and structural welding.

Crane setting structural steel beams into position on a custom residential build
Structural steel beams going in on a custom residential build. One pick at a time until the frame was set.
Rig-mounted 18-inch core drill set up at a parking garage door opening
Rig-mounted 18-inch core drilling at a parking garage door opening. First step of a bollard installation Conrad fabricated and set to the customer's spec.
Straight wet-cut trench lines through a tilt-up warehouse slab
Trench cutting through a tilt-up warehouse slab for a tenant improvement. Straight wet-cut lines, ready for the plumbers.
Welder in full leathers making overhead welds on RTU reinforcement angles
Overhead welding of RTU reinforcement angles for a tenant improvement in an occupied building. Overhead work means full leathers.
Sawn road panel removal on a downtown Denver street for a sewer line replacement
Sawn road panel removal on a downtown Denver street, supporting a civil contractor's sewer line replacement.
Drainage line being guided into an 8-inch core drilled from a vacuum-pad-mounted rig
Guiding a drainage line into an 8-inch core drilled from a vacuum-pad-mounted rig. The vacuum mount meant zero anchor bolts through the client's waterproofing.
After-hours emergency concrete cutting to correct a footer design bust
After-hours emergency cutting to correct a footer design bust. The client formed and poured the replacement footer without losing the schedule.
Custom steel joists craned over a house from the street side and set into place
Custom steel joists, fabricated by Conrad, craned over the entire house from the street side and set into place.
Overhead structural welding on steel reinforcement inside a custom fireplace enclosure
Overhead structural welding on steel reinforcement inside a custom fireplace enclosure at a high-end condominium.
Small-diameter deep coring rig on a vacuum pad with automatic slurry collection
Small-diameter deep coring for a drainage line, run off a vacuum pad with automatic slurry collection. Nothing left on the deck to hose off.
Handheld concrete cutting between rebar dowels on a stem wall
Handheld cutting between rebar dowels on a stem wall. Joist installation on a tight commercial timeline, so there were some late days.
Custom steel storage rack for masonry forms, fabricated and welded onsite
Custom steel storage rack for masonry forms. Too big to ship assembled, so Conrad fabricated and welded it onsite.
Steel joists spanning a CMU wall at the end of an after-hours installation
Steel joists spanning a CMU wall at the end of an after-hours push. The schedule held.
Galvanized steel bollard cored, set, and installed at a roll-up door track
The finished bollard from the garage job: galvanized steel, cored and set at the roll-up door track by Conrad crews.

Your job next

Add your project to this page

Send drawings or a scope description and we'll get you a quote. If it's urgent, call. We answer the phone.

Request a quote (720) 555-0134